Category Archives: Exchange 2010

Microsoft exchange server 2010 | part-2
Step 2 – Configure Active Directory.

At the Server Management screen you should now see that you have 1 role installed. The Active Directory Domain Services may indicate that it is installed but there are errors. This is because the software is installed but not configured.
Microsoft exchange server 2010
Continue reading

Configure Your Static IP Address
exchange2010-ipconfigure2
Leave the IP v6 set to the default setting of DHCP.

NOTE: Exchange requires that IP V6 be enabled. Even if you do not use IP V6 you must leave it enabled. During the setup of Active Directory, the Active Directory Setup Wizard will check that both IP v4 and IP v6 have static addresses. As long as the IP v4 address is static you can continue the installation. DO NOT DISABLE IP V6 or else the Exchange Hub Transport Service will not start.
Continue reading